Setting the map scale

the COMAND To hide the menu: slide the COMAND the COMAND controller and, when the Full screen menu item is shown, press To call up the scale bar: as soon as you.

turn To call up the scale bar: as soon as you turn the COMAND controller, scale the COMAND controller, scale bar 3 appears.

until the desired scale is set. Turn until the desired scale is set. until the desired scale is set.

1 Set map scale as a number with unit

1 Set map scale as a number with unit
2 Currently set map scale as indicated by the needle on the scale bar
3 Scale bar

Unit of measurement 1 in the COMAND display depends on the selection made for the instrument cluster.

    See also:

    Information about driving abroad
    Converting to symmetrical low beam when driving abroad: switch the headlamps to symmetrical low beam in countries in which traffic drives on the opposite side of the road to the country where ...

    Useful information
    This Operator's Manual describes all models and all standard and optional equipment of your vehicle available at the time of publication of the Operator's Manual. Country-specific differenc ...

    Storing and maintaining the current speed
    You can store the current speed if you are driving faster than 20 mph (30 km/h). Accelerate the vehicle to the desired speed. Briefly press the cruise control lever up 1 or down 2. Remove your ...