Selecting an alternative route
With the "Alternative route" function, routes other than the original one can be calculated.
To activate navigation mode: press the function button once or twice.
To show the menu: press the COMAND controller.
Select Route in the navigation system menu bar by turning the COMAND controller and press to confirm.
Select Alternative Route and press to confirm.
You see the selected route. The display now shows a split-screen view. On the left-hand side, one or more alternative routes are shown from start to destination. The current route is highlighted dark blue; other alternative routes appear light blue.
1 Distance, expected arrival time and expected journey duration
2 Displays incidents which are on the route
3 Displays the selected route settings
To select the next or previous alternative route: select Next or Previous and press to confirm.
Possible alternative routes are shown in the following order: Current Route, Fast Route, Eco Route, Short Route and Alternative Route.
To select the original route: select Back a corresponding number of times and press to confirm.
To start route guidance using the selected alternative route: select Start and press to confirm.
COMAND accepts the alternative route.
The change of route mode in the alternative route menu only applies to the current route guidance. For example, if the original route was a short route, the next route will also be calculated as a short route. This is also the case if a dynamic route is selected in the alternative route menu.
See also:
Fuel filler flap
The fuel filler flap is unlocked or locked automatically when you open or close
the vehicle with the SmartKey or using KEYLESSGO.
The position of the fuel filler cap is displayed in the instrument ...
Exhaust check
WARNING
Inhalation of exhaust gas is hazardous to your
health. All exhaust gas contains carbon
monoxide (CO), and inhaling it can cause
unconsciousness and possible death.
Do not run the e ...
Activating the rear view camera
Make sure that the SmartKey is in position 2 in the ignition lock.
Make sure that the "rear view camera" function is selected in COMAND (see
the separate operating instructions for C ...