Safety notes
WARNING
For safety reasons, only enter a destination
when the vehicle is stationary. When the
vehicle is in motion, a passenger should enter
the destination. Study manual and select
route before driving.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximately
14 m) every second.
COMAND calculates the route to the
destination without taking account of the
following:
• Traffic lights
• Stop and right-of-way-signs
• Lane merging
• Parking or stopping prohibited areas
• Other road and traffic rules and regulations
• Narrow bridges
WARNING
COMAND may give incorrect navigation
commands if the data in the digital map does
not correspond with the actual road/traffic
situation. Digital maps do not cover all areas
nor all routes within an area. For example, if
the traffic routing has been changed or the
direction of a one-way road has been
reversed.
For this reason, you must always observe
applicable road and traffic rules and
regulations during your journey. Road and
traffic rules and regulations always have
priority over the navigation commands
generated by the system.
WARNING
Navigation announcements are intended to
direct you while driving without diverting your
attention from the road and driving.
Please always use this feature instead of
consulting the map display for directions.
Looking at the icons or map display can
distract you from traffic conditions and
driving, and increase the risk of an accident.
See also:
Automatic headlamp mode
- To switch on automatic headlamp
mode: turn the light switch to or
.
SmartKey in position 1 in the ignition lock:
the parking lamps are switched on or off
automatically depending on the brig ...
Playback options
Further information on playback options is
available in the "Audio" section.
Select CD, DVD-A or MP3 using
the buttons on the remote
control and press the button to
confirm.
The ...
"Minispare" emergency spare wheel
The "Minispare" emergency spare wheel can
be found in the stowage well under the trunk
floor.
Lift the trunk floor up.
Remove tool kit tray 1.
Turn stowage well ...