Using KEYLESS-GO
The KEYLESS-GO key must be outside the vehicle. All the doors must be closed.
Touch recessed sensor surface 1 on the
door handle until the side windows and the
sliding sunroof or the panorama roof with
power tilt/sliding panel are fully closed.
Make sure you only touch recessed
sensor surface 1.
Make sure that all the side windows and the
sliding sunroof or panorama roof with
power tilt/sliding panel are closed.
To interrupt convenience closing:
release recessed sensor surface 1 on the
door handle.
On vehicles with roller sunblinds:
Touch the recessed sensor surface on the
door handle again until the roller sunblinds
close.
To interrupt the roller sunblind closing
procedure: pull the exterior door handle
and hold it firmly.
Resetting the side windows
You must reset each side window if:
• a side window cannot be closed
automatically
• a side window opens again slightly after
being closed manually
Close all the doors.
Turn the SmartKey to position 1 or 2 in the
ignition lock.
Pull the corresponding switch on the door
control panel until the side window is
completely closed.
Hold the switch for an additional second.
If the side window opens again slightly:
Immediately pull the corresponding switch
on the door control panel until the side
window is completely closed.
Hold the switch for an additional second.
If the corresponding side window remains
closed after the button has been released,
the side window has been reset correctly.
If this is not the case, repeat the steps
above again.
See also:
Making adjustments in 1 mph (Canada: 1 km/h) increments
•► Briefly press the cruise control lever to the pressure point, up 1 for a higher speed or down 2 for a lower speed.
The last speed stored is increased or reduced. ...
Tire pressure monitor warning
messages
If the tire pressure monitor detects a
significant pressure loss on one or more tires,
a warning message is shown in the
multifunction display. A warning tone also
sounds and the tire pressure ...
Storing the current speed or calling upthe last stored speed
WARNING
The set speed stored in memory should only
be set again if prevailing road conditions and
legal speed limits permit. Possible
acceleration or deceleration differences
arising ...