Checking the tire pressures

Important safety notes

WARNING
Follow recommended tire inflation pressures.

Do not underinflate tires. Underinflated tires wear excessively and/or unevenly, adversely affect handling and fuel economy, and are more likely to fail from being overheated.

Do not overinflate tires. Overinflated tires can adversely affect handling and ride comfort, wear unevenly, increase stopping distance, and result in sudden deflation (blowout) because they are more likely to become punctured or damaged by road debris, potholes etc.

Do not overload the tires by exceeding the specified load limit as indicated on the Tire and Loading Information placard on the driver's door B-pillar. Overloading the tires can overheat them, possibly causing a blowout. Overloading the tires can also result in handling or steering problems, or brake failure.

Check the tire pressure at least once a month.

Only check and correct tire pressures when the tires are cold

Checking tire pressure manually

To determine and set the correct tire pressure, proceed as follows:

•► Remove the valve cap of the tire that is to be checked.

•► Press the tire pressure gauge securely onto the valve.

•► Read the tire pressure and compare it with the recommended value on the Tire and Loading Information placard on the B-pillar on the driver's side of your vehicle.

•► If necessary, increase the tire pressure to the recommended value.

•► If the tire pressure is too high, release air by pressing down the metal pin in the valve using the tip of a pen, for example. Then check the tire pressure again using the tire pressure gauge.

•► Screw the valve cap onto the valve.

•► Repeat these steps for the other tires.

    See also:

    Fogged up or dirty windshield
    If the windshield in front of the camera is fogged up or dirty on the inside or outside, the Night View Assist Plus display is affected. WARNING Please do not forget that your primary respons ...

    Manual interior lighting control
    To switch the front interior lighting on/off: press the c button. To switch the rear interior lighting on/off: press the u button. To switch the reading lamps on/off: press the p button. ...

    General notes
    USA only: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. this device must a ...