Fuse box in the engine compartment
•► Make sure that the windshield wipers are turned off.
WARNING
Make sure that the windshield wipers are
switched off and that the SmartKey is
removed from the ignition lock before you
open the cover of the fuse box. Otherwise, the
windshield wipers and the wiper rods above
the cover could be set in motion. This could
lead to you or others being injured by the
wiper rods.
•► Open the hood
•► Remove any existing moisture from the fuse box using a dry cloth.
•► Take lines 2 from the guides.
•► Move aside lines 2. Route the lines behind connection 3 to do this.
•► To open: open clamps 1.
•► Remove the fuse box cover forwards.
Make sure that no moisture can enter the fuse box when the cover is open.
•► To close: check whether the rubber seal is lying correctly in the cover.
•► Insert the cover at the rear of the fuse box into the retainer.
•► Fold down the cover and close clamps 1.
•► Secure lines 2 in the guides.
The cover must be seated properly, otherwise moisture or dirt could impair the function of the fuses.
•► Close the hood
See also:
Activating/deactivating the MONO function
This function is only available in vehicles for Canada.
You can use the MONO function to adopt the temperature and air distribution settings
on the driver's side for the front-passenger side.
...
Important safety notes
Your vehicle may be equipped with a sliding
sunroof or a panorama roof with power tilt/sliding panel. In the following
section, the
term "sliding sunroof" refers to both types of
sli ...
Activating RACE START
Depress the brake pedal with
your left foot, and keep it depressed.
Turn the drive program selector
clockwise until the RS lamp lights up.
The multifunction display shows the RACE
START Conf ...