Charging the battery

WARNING
Never charge a battery still installed in the vehicle unless a battery charger unit approved by Mercedes-Benz is being used. Gases may escape during charging and cause explosions that may result in paint damage, corrosion or personal injury.

A battery charger unit specially adapted for Mercedes-Benz vehicles and tested and approved by Mercedes-Benz is available as an accessory. It permits the charging of the battery in its installed position. Contact an authorized Mercedes-Benz Center for further information and availability.

Charge the battery in accordance with the separate instructions for the battery charger.

WARNING
There is a risk of acid burns during the charging process due to the gases which escape from the battery. Do not lean over the battery during the charging process.

WARNING
Battery acid is caustic. Avoid contact with the skin, eyes or clothing.

Only charge the installed battery with a battery charger which has been tested and approved by Mercedes-Benz. These battery chargers allow the battery to be charged while still installed.

Only use battery chargers with a maximum charging voltage of 14.8 V.

Only charge the battery using the jumpstarting connection point.

The jump-starting connection point is in the engine compartment

•► Open the hood

•► Connect the battery charger to the positive terminal and earth point in the same order as when connecting the donor battery in the jump-starting procedure

•► Read the battery charger's operating instructions before charging the battery.

    See also:

    Fast forward/rewind
    Slide and hold the COMAND controller until the desired position has been reached. You see the navigation menu. ...

    Switching to audio CD, audio DVD or MP3 mode
    Insert a CD/DVD. The Rear Seat Entertainment System loads the inserted disc. Select Disc in the menu using the buttons on the remote control and press the button to confirm. The corresp ...

    Switching the front climate control on/off using the front control panel
    Turn the SmartKey to position 2 in the ignition lock. To activate: press the rocker switch up or down. The indicator lamp in the rocker switch goes out. The previously selected settings ...