Opening/closing the garage door

Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.

•► Turn the SmartKey to position 2 in the ignition lock.

•► Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door.

Garage door system with a fixed code:

indicator lamp 1 lights up green.

Garage door system with a rolling code:

indicator lamp 1 flashes green.

The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.

    See also:

    Important notes on tire pressure
    WARNING Should the tire pressure drop repeatedly:  - check the tire for foreign bodies.  - check whether the wheel is losing air or the valve is leaking.  - make sure that onl ...

    Maintenance
    The Service and Warranty Booklet describes all the necessary maintenance work which should be done at regular intervals. Always have the Service and Warranty Booklet with you when you bring the ...

    Hill start assist
    Hill start assist helps you when pulling away forwards or in reverse on an uphill gradient. It holds the vehicle for a short time after you have removed your foot from the brake pedal. This give ...