introduction
You can establish a Bluetooth® connection to COMAND (see the separate operating instructions).
WARNING
A driver's attention to the road must always
be his/her primary focus when driving. For
your safety and the safety of others, we
recommend that you pull over to a safe
location and stop before placing or taking a
telephone call. If you choose to use the
telephone while driving, please use the handsfree
device and only use the telephone when
weather, road and traffic conditions permit.
Some jurisdictions prohibit the driver from using a mobile phone while driving a vehicle.
Bear in mind that at a speed of just 30 mph (approximately 50 km/h ), your vehicle is covering a distance of 44 feet (approximately 14 m) every second.
•► Switch on the mobile phone and COMAND (see the separate operating instructions).
•► Press the 
button on the
steering wheel to select the Tel menu.
You will see one of the following display messages in the multifunction display:
- Telephone Ready or the name of the
network provider: the mobile phone has
found a network and is ready to receive.
- Phone No Service: no network is
available, or the mobile phone is searching
for a network.
See also:
Activating/deactivating the residual heat function
The residual heat function is only available in
vehicles for Canada with automatic climate
control.
It is possible to make use of the residual heat
of the engine to continue heating the
stati ...
Maximum load rating
WARNING
Do not overload the tires by exceeding the
specified load limit as indicated on the Tire
and Loading Information placard on the
driver's door B-pillar. Overloading the tires
can ove ...
Engine number
1 Emission control information plate,
including the certification of both federal
and Californian emissions standards
2 Engine number (stamped into the
crankcase)
3 VIN (on the lower edge of ...