Activating RACE START

•► Depress the brake pedal with your left foot, and keep it depressed.

•► Turn the drive program selector clockwise until the RS lamp lights up.

The multifunction display shows the RACE START Confirm: Paddle UP Cancel:

Paddle DOWN message

If the conditions for activation are no longer fulfilled, RACE START is canceled.

The multifunction display shows the RACE START canceled message.

•► To cancel: pull the left steering wheel shift paddle
or
•► To confirm: pull the right steering wheel shift paddle.

The multifunction display shows the RACE START available Depress accelerator message.

If you do not depress the accelerator pedal fully within two seconds, RACE START is canceled. The multifunction display shows the RACE START not possible See Operator's Manual message.

•► Depress the accelerator pedal fully.

The engine speed increases to approximately 4000 rpm.

The multifunction display shows the RACE START Release brake to start message.

If you do not release the brake pedal within seven seconds, RACE START is canceled. The multifunction display shows the RACE START canceled message.

Take your foot off the brake, but keep the accelerator pedal depressed.

The vehicle pulls away at maximum acceleration.

The multifunction display shows the RACE START active message.

RACE START is deactivated when a speed of approximately 30 mph (Canada: 50 km/h) is reached. Drive program S+ is activated.

SPORT handling mode remains activated.

RACE START is deactivated immediately if you release the accelerator pedal during RACE START or if any of the activation conditions are no longer fulfilled. The multifunction display shows the RACE START not possible See Operator's Manual message

If RACE START is used repeatedly within a short period of time, it is only available again after the vehicle has been driven a certain distance.

    See also:

    Xenon bulbs
    If your vehicle is equipped with Xenon bulbs, you can recognize this by the following: the cone of light from the Xenon bulbs moves from the top to the bottom and back again when you start the ...

    Manual interior lighting control
    To switch the front interior lighting on/off: press the c button. To switch the rear interior lighting on/off: press the u button. To switch the reading lamps on/off: press the p button. ...

    Using KEYLESS-GO to start the engine
    WARNING As long as the SmartKey is in your vehicle, the vehicle can be started. Therefore, never leave children unattended in the vehicle, as they could otherwise accidentally start the engi ...