Deactivating/activating the ECO start/ stop function

Example: ECO button

Example: ECO button

If indicator lamp 2 is off, the ECO start/ stop function has been deactivated manually or as the result of a malfunction.

The engine will then not be switched off automatically when the vehicle stops.

mostbet mostbet mostbet

Every time you start the engine, the ECO start/stop function is switched on and the automatic transmission shifts to automatic drive program C.

Deactivating

•► In drive program C, press button 1.
or
•► Switch to drive program S, S+ or M.

Indicator lamp 2 on button 1 and the go symbol in the multifunction display go out.

The Stop/Start active or Stop/Start inactive message disappears in the AMG menu in the multifunction display.

Activating

•► Press button 1.

Indicator lamp 2 lights up. If drive program S, S+ or M is selected, the automatic transmission switches to drive program C.

If all conditions for automatic engine switch-off are fulfilled, the multifunction display. In addition, the symbol is shown in green in the multifunction display. In addition, the Stop/Start active display message is shown in the AMG menu in the multifunction display.

If not all conditions for automatic engine switch-off are fulfilled, the Stop/Start inactive display message and the in the AMG menu in the multifunction symbol are shown in yellow in the AMG menu in the multifunction display. If this is the case, the ECO start/ stop function is not available.

    See also:

    Direction of rotation
    Tires with a specified direction of rotation have additional benefits, e.g. if there is a risk of hydroplaning. You will only gain these benefits if the correct direction of rotation is mainta ...

    The first 1000 miles (1500 km)
    The more you look after the engine when it is new, the more satisfied you will be with its performance in the future. • Drive at varying vehicle speeds and engine speeds for the first 1000 mile ...

    Storing a phone number which has not yet been stored
    Introduction For incoming calls from a person who is not in the address book, COMAND displays the phone number in the call list. You can save this entry. Storing as a new entry in the address ...