Resetting the panorama roof with power tilt/sliding panel and the roller sunblinds
Reset the panorama roof with power tilt/ sliding panel and the roller sunblinds if the panorama roof with power tilt/sliding panel or the roller sunblinds do not move smoothly.
•► Turn the SmartKey to position 1 or 2 in the ignition lock.
•► Pull the 
switch repeatedly to the
point
of resistance in the direction of arrow 3
until the panorama roof with power tilt/
sliding panel is fully closed.
•► Keep the switch pulled for an
additional second.
•► Pull the switch repeatedly to
the point
of resistance in the direction of arrow 3
until the roller sunblinds are fully closed.
•► Keep the switch pulled for an
additional second.
•► Make sure that the panorama roof with power tilt/sliding panel and the roller sunblinds can be fully opened again.
•► If this is not the case, repeat the steps above again.
If the panorama roof with power tilt/ sliding panel and the roller sunblind cannot be fully opened or closed after resetting, contact a qualified specialist workshop.
See also:
Transfer case
This section is only valid for vehicles with 4- wheel drive (4MATIC). Power is
always transmitted to both axles.
Performance tests may only be carried out on a 2-axle dynamometer. The brake
sy ...
Service menu
In the Serv. menu you can:
- call up display messages
- restart the tire pressure loss warning
system (Canada only) Rcheck the tire pressure electronically
- call up the ...
Notes for 4MATIC vehicles
Vehicles with 4MATIC must not be towed
with either the front or the rear axle raised,
as doing so will damage the transmission.
If the vehicle has transmission damage or
damage to the front or ...