Opening and closing

Overhead control panel

Overhead control panel

1. To raise
2. To open
3. To close/lower

The panorama roof with power tilt/sliding panel can only be operated when the roller sunblind is open.

•► Turn the SmartKey to position 1 or 2 in the ignition lock.

•► Push or pull the corresponding direction. switch in the corresponding direction.

If you press the the switch beyond the point of resistance, an automatic opening/ closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

    See also:

    Changing the set speed whilethe vehicle is in motion
    When DSR is activated, the control speed can be changed to a value between 3 mph and 10 mph (Canada: between 4 km/h and 18 km/h) during the journey. ► To increase or decrease in 1 mph (Ca ...

    Call priority
    When service calls are active, e.g. Roadside Assistance or MB Info calls, an emergency call can still be initiated. In this case, an emergency call will take priority and override all other active ...

    Cargo tie-down rings
    Observe the following notes on securing loads: • secure the load using the cargo tie down rings. • do not use elastic straps or nets to secure a load, as these are only intended as an anti-s ...