Changing the settings of the locking system

You can change the setting of the locking system in such a way that only the driver's door and the fuel filler flap are unlocked. This is useful if you frequently travel on your own.

•► To change the setting: press and hold down the buttons and simultaneously for approximately six buttons simultaneously for approximately six seconds until the battery check lamp  flashes twice.

If the setting of the locking system is changed within the signal range of the vehicle, pressing the button or locks or unlocks the vehicle. button locks or unlocks the vehicle.

The SmartKey now functions as follows:

•► To unlock the driver's door: press the button once.
•► To unlock centrally: press the button twice.•► To lock centrally: press the button twice.
•► To lock centrally: press the The KEYLESS-GO function is changed as button.

The KEYLESS-GO function is changed as follows:

•► To unlock the driver's door: touch the inner surface of the door handle on the driver's door.
•► To unlock centrally: touch the inner surface of the door handle on the frontpassenger door or the rear door.
•► To lock centrally: touch the outer sensor surface on one of the door handles.

    See also:

    Important safety notes
    WARNING It is dangerous to shift the automatic transmission out of parking position P or neutral position N if the engine speed is higher than idle speed. If your foot is not firmly on the ...

    BAS PLUS (Brake Assist System Plus)
    BAS PLUS is only available in vehicles equipped with DISTRONIC PLUS. Observe the "Important safety notes" section. At speeds above approximately 20 mph (30 km/h), BAS PLUS assists ...

    Climate control main menu
    COMAND allows you to set additional functions which cannot be selected using the control panel in the center console. Call up these functions using the climate control main menu. To open the ...