Seat belt adjustment
The seat-belt adjustment function adjusts the driver's and front-passenger seat belt to the upper body of the occupants.
The belt strap is tightened slightly when:
- you engage the belt tongue in the belt
buckle and you then turn the SmartKey to
position 2 in the ignition lock.
- the SmartKey is in position 2 in the ignition
lock and you then engage the belt tongue
in the buckle.
The seat-belt adjustment will apply a retraction force if any slack is detected between the occupant and the seat belt. Do not hold on to the seat belt tightly while it is adjusting. You can switch the seat-belt adjustment on and off in the on-board computer.
The seat-belt adjustment is an integral part of the PRE-SAFE® convenience function. More information about PRE-SAFE® can be found in the "PRE-SAFE® (preventative occupant protection)" section.
See also:
Adjusting the climate mode settings (AIR FLOW)
This function is only available with 3-zone
automatic climate control.
The climate mode settings are especially
effective at high temperatures.
You can select the following climate mode
settin ...
Drive sensibly – save fuel
Observe the following tips to save fuel:
The tires should always be inflated
to the recommended tire pressure.
Remove unnecessary loads.
Remove roof racks when they are not
needed.
Warm up ...
Setting the temperature in the rear
compartment using the rear control
panel
Turn the SmartKey to position 2 in the
ignition lock.
To increase/reduce: press rocker
switch 12 or 17 up or down.
Only change the temperature setting in
small increments. Start at 72 °F (22 ...