Restarting the tire pressure loss warning system

Restart the tire pressure loss warning system if you have:
• changed the tire pressure
• changed the wheels or tires
• mount new wheels or tires

Loading Information placard on the  Before restarting, consult the Tire and Loading Information placard on the B-pillar on the driver's side or the tire pressure table on the inside of the fuel filler flap to ensure the tire pressure in all four tires is set correctly for the current operating conditions.
pressures  Observe the notes in the section on tire pressures

WARNING
The tire pressure loss warning system can only give reliable warnings if you have set the correct tire pressure.
If an incorrect tire pressure is set, these incorrect values will be monitored.
A tire with insufficient pressure results in vehicle instability when driving, thus increasing the risk of an accident.

position 2 in the ignition lock.  Make sure that the SmartKey is in position 2 in the ignition lock.
or  Press the button to select the or Service menu. button to select the Service menu.
or  Press the button to select or Tire Pressure. button to select Tire Pressure.
button.  Press the The Run Flat Indicator Active button.
The Run Flat Indicator Active Press 'OK' to Restart message appears in the multifunction display.

If you wish to confirm the restart:

button.  Press the The Tire Pressure Now OK? message button.
The Tire Pressure Now OK? message appears in the multifunction display.
or  Press to select Yes. or   Press the to select Yes.
button.  Press the The Run Flat Indicator Restarted button.
The Run Flat Indicator Restarted message appears in the multifunction display.
After a teach-in period, the tire pressure loss warning system will monitor the set tire pressures of all four tires.

If you wish to cancel the restart:

or  Press the or button.
or
appears, press  If the Tire Pressure Now OK? message appears, press to select or Cancel. to select Cancel.
button.  Press the The tire pressure values stored at the last button.
The tire pressure values stored at the last restart will continue to be monitored.

    See also:

    Vehicle identification plate
    Even if you have calculated the total load carefully, you should still make sure that the gross vehicle weight rating and the gross axle weight rating are not exceeded. Details can be found on ...

    Starting procedure with the SmartKey
    To start the engine using the SmartKey instead of KEYLESS-GO, pull the Start/ Stop button out of the ignition lock. X Turn the SmartKey to position 3 in the ignition lock () and release it as ...

    Important safety notes
    WARNING On slippery road surfaces, never downshift in order to obtain braking action. This could result in drive wheel slip and reduced vehicle control. Your vehicle's ABS will not prevent ...