Power washers

WARNING
Do not use power washers with circular-jet nozzles (dirt grinders) to clean your vehicle, in particular the tires. You could otherwise damage the tires and cause an accident.

least Always maintain a distance of at least 11.8 in (30 cm) between the vehicle and the power washer nozzle. Information about the correct distance is available from the equipment manufacturer.
Move the power washer nozzle around when cleaning your vehicle.
Do not aim directly at any of the following:
• tires
• door gaps, roof gaps, joints etc.
• electrical components
• battery
• connectors
• lights
• seals
• trim elements
• ventilation slots
Damaged seals or electrical components can lead to leaks or failures.

    See also:

    Emergency Tensioning Devices, belt force limiters
    The front seat belts and the outer seat belts in the rear are equipped with ETDs and seat belt force limiters. The ETDs tighten the seat belts in an accident, pulling them close against the bod ...

    EBD (electronic brake force distribution)
    Observe the "Important safety notes" section. EBD monitors and controls the brake pressure on the rear wheels to improve driving stability while braking. WARNING If EBD has malfu ...

    Setting the front-compartment temperature using the front control panel
    Turn the SmartKey to position 2 in the ignition lock. To increase/reduce: press the rocker switch up or down. Only change the temperature setting in small increments. Start at 72 °F (22 °C ...