Calibrating the compass

sufficient space for Make sure that there is sufficient space for you to drive in a circle without impeding the remaining traffic.

In order to calibrate the compass correctly, observe the following points:
• calibrate the compass in the open and not in the vicinity of steel constructions or highvoltage transmission lines.
• switch off electrical consumers, for example, the climate control, windshield wipers or rear window defroster.
• close all doors and the trunk lid.

Press a round pin into opening 3 Switch the ignition on.
for approximately six seconds Press a round pin into opening 3 for approximately six seconds until the C symbol appears in compass display 2.
approximately 3 mph Drive a full circle at approximately 3 mph (5 km/h) to 6 mph (10 km/h).
Once the calibration has been successfully completed, the current direction appears in compass display 2.

    See also:

    Important safety notes
    DSR is an aid to assist you when driving downhill. It keeps the speed of travel at the speed selected on the on-board computer. The steeper the downhill gradient, the greater the DSR braking eff ...

    Functions of the number keypad
    You can use the remote control to execute the same functions as the COMAND control panel. Mode Function Audio mode Selects stations via the station presets Sets stations ...

    Switching the rear-compartment climate control on/off using the rear control panel
    Turn the SmartKey to position 2 in the ignition lock. To switch on: press rocker switch 15 up or down and select AUTO. or Press rocker switch 15 up or down and select MAN. To switch of ...