Opening/closing the garage door

Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.

in the Turn the SmartKey to position 2 in the ignition lock.
in the Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door.
Garage door system with a fixed code: indicator lamp 1 lights up green.
Garage door system with a rolling code: indicator lamp 1 flashes green.

signal for The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.

    See also:

    Safety systems
    Problem Possible causes/consequences and Solutions (USA only) (Canada only) The red brake system warning lamp comes on while the engine is running. A warning to ...

    Real-time traffic reports on the map
    COMAND can show certain traffic incidents on the map. The incidents are shown on the map at a scale from 1/16 mi to 20 mi. Set the map scale. 12 Icon display for the section of route affected ...

    Deactivating DISTRONIC PLUS
    There are several ways to deactivate DISTRONIC PLUS: •► Briefly press the cruise control lever forwards 1. or•► Brake, unless the vehicle is stationary. When you deactivate DIS ...