Activating the rear view camera
Make sure that the SmartKey is
in position 2 in the ignition lock.
Make sure that the "rear view
camera" function is selected in COMAND (see the separate operating instructions
for COMAND).
Engage reverse gear.
The area behind the vehicle is shown in the COMAND display.
See also:
Useful information
This Operator's Manual describes all models and all standard and optional equipment
of your vehicle available at the time of publication of the Operator's Manual. Country-specific
diffe ...
Trailer towing
- Drive in the middle of the engine speed
range on uphill gradients.
- Depending on the uphill or downhill
gradient, shift down into shift range 3 or
2, even if cruise control or
DISTRONIC PL ...
General notes
USA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and
2. this device mus ...