Tail lamp

Open the trunk. Switch off the lights.
Open the side trim panel. Open the trunk.
Open the side trim panel.

Remove the tail lamp connector

Simultaneously press retaining lugs Remove the tail lamp connector
1 in the direction of the arrow and slightly pull out the bulb holder with the Simultaneously press retaining lugs 1 in the direction of the arrow and slightly pull out the bulb holder with the bulbs.
functions from the top of the bulb holder. Remove the connector for LED light functions from the top of the bulb holder.
bulbs. Pull the bulb holder out with the bulbs.

1 Backup lamp

1 Backup lamp
2 Brake lamp
3 Parking lamp/brake lamp

or 3 back and turn it counter-clockwise to remove it from the bulb holder. Press the respective bulb 1, 2 or 3 back and turn it counter-clockwise to remove it from the bulb holder.
holder and turn it clockwise. Insert the new bulb into the bulb holder and turn it clockwise.
light functions in the bulb holder. Reinsert the connector for LED light functions in the bulb holder.
lock it in place. Insert the bulb holder again and lock it in place.
Close the side trim panel Insert the tail lamp connector.
Windshield wipers Close the side trim panel

    See also:

    LATCH-type (ISOFIX) child seat anchorsin the rear
    WARNING   Children that are too large for a child restraint must travel in seats using normal seat belts. Position shoulder belt across the chest and shoulder, not face or neck. In orde ...

    Activating/deactivating the residual heat function
    The residual heat function is only available in vehicles for Canada with automatic climate control. It is possible to make use of the residual heat of the engine to continue heating the stati ...

    Vehicle
    Display messages Possible causes/consequences and Solutions Shift to 'P' or 'N' to Start Engine You have attempted to start the engine with the transmission i ...