Resetting the panorama roof with power tilt/sliding panel and the roller sunblinds
Reset the panorama roof with power tilt/sliding panel and the roller sunblinds if the panorama roof with power tilt/sliding panel or the roller sunblinds do not move smoothly.
Turn the SmartKey to position
1 or 2 in the ignition lock.
Press the
switch to the point of
resistance in the direction of arrow 2 and
hold it until the panorama roof with power
tilt/sliding panel has opened about 4 in
(10 cm).
Pull the
switch repeatedly to the point
of resistance in the direction of arrow 3
until the panorama roof with power tilt/sliding panel is fully closed.
Keep the
switch pulled for an additional
second.
Press the
switch to the point of resistance
in the direction of arrow 2 and hold it until the sunblinds have opened about 4
in (10 cm).
Pull the
switch repeatedly to the point
of resistance in the direction of arrow 3
until the roller sunblinds are fully closed.
Keep the
switch pulled for an
additional second.
Make sure that the panorama roof
with
power tilt/sliding panel and the roller
sunblinds can be fully opened and closed
again.
If this is not the case, repeat the
steps
above again.
If the panorama roof with power
tilt/sliding panel and the roller sunblind cannot
be fully opened or closed after resetting,
contact a qualified specialist workshop.
See also:
Checklist before driving off-road
– Engine oil level: check the engine oil and
add oil if necessary.
When driving on steep gradients, the oil
level must be sufficiently high to ensure a
correct oil supply in the vehicle.
– DEF ...
Coupling up a trailer
WARNING
Vehicles with air suspension program: While
you are coupling or decoupling a trailer, make
sure nobody locks or unlocks the vehicle and/or opens or closes doors or the
tailgate.
The v ...
Low-beam headlamps
To switch on the low-beam headlamps: turn the SmartKey in the ignition
lock to position 2 or start the engine.
Turn the light switch to .
The indicator lamp in the instrument
cluster li ...