Operating the panorama roof with power tilt/sliding panel

Opening and closing

Overhead control panel
Overhead control panel

1 To raise
2 To open
3 To close/lower

The panorama roof with power tilt/sliding panel can only be operated when the roller sunblind is open.

or 2 in the ignition lock. Turn the SmartKey to position 1 or 2 in the ignition lock.
switch in the corresponding Push or pull the direction. switch in the corresponding direction.

switch beyond the If you press the point of resistance, an automatic opening/closing process is started in the switch beyond the point of resistance, an automatic opening/closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.
When raising the roof, automatic operation is only available if the panorama roof with power tilt/sliding panel is in the closed position.

    See also:

    Cleaning the plastic trim
    WARNING When cleaning the steering wheel boss and dashboard, do not use cockpit sprays or cleaning agents containing solvents. Cleaning agents containing solvents cause the surface to become ...

    Opening and closing
    You can continue to operate the sliding sunroof after switching off the engine or removing the SmartKey from the ignition lock. This function is available for up to five minutes or until the d ...

    Switching on/off
    The three blue indicator lamps in the buttons indicate the ventilation level you have selected. If the battery voltage is too low, the seat ventilation may switch off. ► Make sure that ...