Using KEYLESS-GO

The KEYLESS-GO key must be outside the vehicle. All the doors must be closed.

Touch recessed sensor surface 1

on the Touch recessed sensor surface 1 on the door handle until the side windows and the sliding sunroof or the panorama roof with power tilt/sliding panel are fully closed.

recessed Make sure you only touch recessed sensor surface 1.

windows and the Make sure that all the side windows and the sliding sunroof or panorama roof with power tilt/sliding panel are closed.

On vehicles with a panorama roof with power tilt/sliding panel:
the door handle again until the roller sunblinds of the panorama roof with power Touch recessed sensor surface 1 on the door handle again until the roller sunblinds of the panorama roof with power tilt/sliding panel close.
closing: release recessed sensor surface 1 on the door handle. To interrupt convenience closing: release recessed sensor surface 1 on the door handle.

    See also:

    Cleaning the display
      Before cleaning the display, make sure that it is switched off and has cooled down.   Clean the display surface using a commercially-available microfiber cloth and TFT/LCD display c ...

    Selecting the screen for the remote control
    Turn thumbwheel 3 until the desired display is highlighted in the window. ...

    Introduction
    You can establish a Bluetooth® connection to COMAND (see the separate operating instructions). WARNING A driver's attention to the road must always be his/her primary focus when driving. For ...