Opening/closing the garage door
Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
– Turn the SmartKey to position 2 in the
ignition lock.
– Press transmitter button 2, 3 or 4 in the
overhead control panel that you have
programmed to operate the garage door.
Garage door system with a fixed code:
indicator lamp 1 lights up green.
Garage door system with a rolling code:
indicator lamp 1 flashes green.
The transmitter will transmit a signal for
as long as the transmitter button is being
pressed. After a maximum of ten seconds,
transmission is terminated and indicator
lamp 1 flashes yellow. Press the
transmitter button again, if necessary.
See also:
Activating/deactivating the residual
heat function
The residual heat function is only available in
Canada
It is possible to make use of the residual heat
of the engine to continue heating the
stationary vehicle for up to 30 minutes after
the ...
Fuel requirements
Use only premium-grade unleaded gasoline. The octane number
should be at least 91. Details can be found on the gas pump. The octane number is
the average value of the Research Octane Number (RON) ...
Selecting a category/playlist/folder
iPod® and certain MP3 players
For an iPod® or MP3 player, you can select
tracks using categories or folders.
Depending on the device connected, the
following categories may be available, for
e ...