Points to observe before use

With the exception of the socket in the front center console, all sockets can be used for accessories with a maximum current draw of 240 W (20 A), e.g. lamps or chargers for mobile phones.

The socket in the center console in the front compartment can be used for accessories, e.g lamps or mobile phone chargers with a maximum current draw of 180 W (15 A).

If you use the sockets for long periods when the engine is switched off, the battery may discharge.

– Turn the SmartKey to position 1 in the ignition lock.

An emergency cut-out ensures that the An emergency cut-out ensures that the on-board voltage does not drop too low. If the on-board voltage is too low, the power to the sockets is automatically cut. This ensures that there is sufficient power to start the engine.

    See also:

    Emergency Tensioning Devices, belt force limiters
    The front seat belts and the outer seat belts in the rear are equipped with ETDs and seat belt force limiters. The ETDs tighten the seat belts in an accident, pulling them close against the bod ...

    Low-beam headlamps
    To switch on the low-beam headlamps: turn the SmartKey in the ignition lock to position 2 or start the engine. Turn the light switch to . The indicator lamp in the instrument cluster li ...

    Change of direction
    Introduction Changes of direction have three phases: • preparation phase • announcement phase • change-of-direction phase Preparation phase COMAND prepares you for the upcoming change of ...