Telescopic rod
The telescopic rod can be used to secure the load against the rear seats to prevent it from moving around.

– To install: insert one bracket 2 into both
the left and the right loading rails and slide
it to the desired position.
– Insert telescopic rod 1 into brackets 2
and, while doing so, press release
button 4 and push the rod downwards
until it engages.
– Make sure that locking button 3 on
brackets 2 is pressed.
This keeps brackets 2 in place on the
loading rail.
– To remove: press release button 4 on
respective bracket 2 and remove
telescopic rod 1 by pulling it upwards and
out.
See also:
Weight specifications
The gross trailer weight is calculated by
adding the weight of the trailer to the weight
of the load and equipment on the trailer.
Maximum gross vehicle weight:.
The maximum permissible trailer ...
Compass
Calling up the compass
► Press the
button on the
multifunction steering wheel repeatedly
until the Offroad menu appears in the
multifunction display.
The compass shows which direction t ...
Ruts and gravel roads
Observe the following rules when driving
along ruts in off-road terrain or on roads with
loose gravel:
Check that the ruts are not too deep and
that your vehicle has sufficient clearance.
...
