Activating the HOLD function

– Make sure that the activation conditions are met.
– Depress the brake pedal.

– Quickly depress the brake pedal further

– Quickly depress the brake pedal further until HOLD display 1 appears in the multifunction display.
The HOLD function is activated. You can release the brake pedal.

If depressing the brake pedal the first If depressing the brake pedal the first time does not activate the HOLD function, wait briefly and then try again.

The vehicle's brakes are applied when the WARNING
The vehicle's brakes are applied when the HOLD function is activated. For this reason, deactivate the HOLD function if the vehicle is to be set in motion by other means (e.g. in a car wash or by towing).

    See also:

    Switching on/off
    The three blue indicator lamps in the buttons indicate the ventilation level you have selected. If the battery voltage is too low, the seat ventilation may switch off. ► Make sure that ...

    High-performance brake system for AMG vehicles
    The high-performance brake system is installed only on the C 63 AMG. WARNING New vehicle brake pads and discs, and replacement brake pads and discs may take several hundred miles of driving ...

    Reporting safety defects
    If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) ...