Engaging park position P automatically

Park position P is automatically engaged if:
- you switch off the engine using the SmartKey and remove the SmartKey, or if you switch off the engine using the Start/Stop button and open one of the front doors.
- the HOLD function (Y page 179) or DISTRONIC PLUS (Y page 169) brakes your vehicle until it is stationary and at least one of the following conditions is fulfilled:
    - there is a system malfunction.
    - there is a severe uphill or downhill slope.
The electric parking brake is then also applied.

    See also:

    Limited braking performance on salttreated roads
    WARNING The layer of salt on the brake discs and the brake pads/linings may cause a delay in the braking effect, resulting in a significantly longer braking distance, which could lead to an ...

    Problems with the seat heating
    The seat heating has switched off prematurely or cannot be switched on. The vehicle's electrical system voltage is too low because too many electrical consumers are switched on. X Switch off ...

    Cleaning the seat belts
    ► Use clean, lukewarm water and soap solution. Do not clean the seat belts using chemical cleaning agents. Do not dry the seat belts by warming them above 176 °F (80 °C) or placing them i ...