Using KEYLESS-GO
The KEYLESS-GO key must be outside the vehicle. All the doors must be closed.
- Touch recessed sensor surface 1 on the door handle until the side windows and the sliding sunroof or the panorama roof with power tilt/sliding panel are fully closed.
Make sure you only touch
recessed
sensor surface 1.
- Make sure that all the side windows and the sliding sunroof or panorama roof with power tilt/sliding panel are closed.
On vehicles with a panorama roof with power
tilt/sliding panel:
- Touch recessed sensor surface 1 on the
door handle again until the roller sunblinds
of the panorama roof with power tilt/sliding panel close.
- To interrupt convenience closing:
release recessed sensor surface 1 on the
door handle.
See also:
ETS/4ETS (Electronic Traction System)
WARNING
Observe "Important safety notes"
Traction control is part of ESP®.
Traction control brakes the drive wheels
individually if they spin. This enables you to
pull away and ac ...
Creating new contacts/changing
contacts
In certain countries, this function stops
being available from a vehicle speed of
more than approximately 3 mph (5 km/h).
As soon as the speed falls below
approximately 2 mph (3 km/h), the
f ...
Cleaning the seat belts
Use clean, lukewarm water and soap
solution.
Do not clean the seat belts
using chemical
cleaning agents. Do not dry the seat belts
by warming them above 176 °F (80 °C) or
placing th ...