On-board diagnostic interface

If you connect equipment to the on-board WARNING
If you connect equipment to the on-board diagnostics interface, it can affect the operation of the vehicle systems. This can impair the operating safety of your vehicle while driving. There is a risk of accident.
Do not connect any equipment to the onboard diagnostics interface.

Loose equipment or equipment cables which WARNING
Loose equipment or equipment cables which are connected to the on-board diagnostics interface can obstruct the area around the pedals. The equipment or the cables could get between the pedals in the event of sudden braking or acceleration. You may then no longer be able to brake, operate the clutch or accelerate as intended. There is a risk of accident.
Do not attach any equipment or cables in the driver footwell.

Connecting equipment to the on-board diagnostics interface can lead to emissions monitoring information being reset. This may lead to the vehicle failing to meet the requirements at the next special emissions test or main inspection.

If the engine is switched off and equipment on the on-board diagnostic interface is used, the starter battery may discharge.

The on-board diagnostics interface is only intended for the connection of diagnostic equipment at a qualified specialist workshop.

    See also:

    Important safety notes
    Do not leave the SmartKey in the cargo compartment. You could otherwise lock yourself out. WARNING When leaving the vehicle, always remove the SmartKey from the ignition lock. Always take t ...

    Important safety notes
    WARNING Inhalation of exhaust gas is hazardous to your health. All exhaust gas contains carbon monoxide (CO), and inhaling it can cause unconsciousness and possible death. Do not run the e ...

    Trailer towing
    - Drive in the middle of the engine speed range on uphill gradients. - Depending on the uphill or downhill gradient, shift down into shift range 3 or 2, even if cruise control or DISTRONIC PL ...