Restarting the tire pressure monitor

WARNING It is the driver's responsibility to set the tire 
It is the driver's responsibility to set the tire pressure to the recommended cold tire pressure. Underinflated tires affect the ability to steer or brake the vehicle. You might lose control over the vehicle.

When you restart the tire pressure monitor, all existing warning messages are deleted and the warning lamps go out. The monitor uses the currently set tire pressures as the reference values for monitoring.

The tire pressure monitor must be restarted when you set the tire pressure to a new value (as a result of changed drive or load characteristics, for example). The tire pressure monitor then monitors the new tire pressure values.

Restart the tire pressure monitor after you have set the tire pressure to the value recommended for the desired driving situation. Only correct tire pressures on cold tires. Comply with the recommended tire pressures on the tire and loading information table on the B-pillar on the driver's side. Additional tire pressure values for driving at high speeds or with heavy loads can be found in the tire pressure table on the inside of the fuel filler flap.

► Make sure that the tire pressure is correct on all four wheels.
► Make sure that the SmartKey is in position 2 in the ignition lock.
► Press and hold the V or U button on the multifunction steering wheel until the standard display appears in the multifunction display.
► Press and hold the until the tire pressure of each wheel or the button until the tire pressure of each wheel or the Tire pressure displayed after driving for a few minutes message appears.
► Press the reset button on the instrument cluster.

The Restart tire pressure monitor? message appears in the multifunction display.

If you wish to confirm the restart:

► Press the button.

The Tire Pressure Monitor Restarted message appears in the multifunction display.

After driving for a few minutes, the system checks whether the current tire pressures are within the specified range. The new tire pressures are then accepted as reference values and monitored.

If you wish to cancel the restart:

► Press the button.

The tire pressure values stored at the last restart will continue to be monitored.

    See also:

    Switching on/off
    The three red indicator lamps in the button indicate the heating level you have selected. If the battery voltage is too low, the seat heating may switch off. The system automatically switches ...

    Useful information
    This Operator's Manual describes all models and all standard and optional equipment of your vehicle available at the time of publication of the Operator's Manual. Country-specific differences ...

    Lowering the vehicle
    ► Place the ratchet wrench onto the hexagon nut of the jack so that the letters AB are visible. ► Turn the ratchet wrench until the vehicle is once again standing firmly on the gro ...