Tire pressure of at least 180 kPa(1.8 bar/26 psi) is not reached
If, after five minutes, a pressure of 180 kPa (1.8 bar/26 psi) has not been achieved:
► Press the on/off switch on the tire inflation compressor to 0.
The tire inflation compressor is switched off.
► Unscrew the filler hose from the valve of
the faulty tire.
► Very slowly drive forwards or reverse
approximately 30 ft (10 m).
► Pump up the tire again.
WARNING 
If after five minutes a pressure of 180 kPa
(1.8 bar/26 psi) cannot be achieved, the tire
is too badly damaged to be repaired reliably
using TIREFIT.
In this case TIREFIT cannot seal the tire
properly.
Do not drive any further.
Contact the nearest authorized Mercedes-Benz Center for assistance or call
Roadside
Assistance.
See also:
Drive sensibly – save fuel
Observe the following tips to save fuel:
The tires should always be inflated
to the recommended tire pressure.
Remove unnecessary loads.
Remove roof racks when they are not
needed.
Warm up ...
Making adjustments in 1 mph (Canada:1 km/h) increments
► Briefly press the cruise control lever
to the
pressure point, up 1 for a higher speed or
down 2 for a lower speed.
The last speed stored is increased or
reduced. ...
Increased vehicle weight due to optional equipment
This is the combined weight of all standard
and optional equipment available for the
vehicle, regardless of whether it is actually
installed on the vehicle or not. ...