Loading guidelines
WARNING
Always fasten items being carried as securely
as possible. Use cargo tie-down rings and
fastening materials appropriate for the weight
and size of the load.
In an accident, during hard braking or sudden
maneuvers, loose items will be thrown around
inside the vehicle. This can cause injury to
vehicle occupants unless the items are
securely fastened in the vehicle.
To help avoid personal injury during a collision
or sudden maneuver, exercise care when
transporting cargo. Do not pile luggage or
cargo higher than the seat backrests.
The cargo compartment is the preferred place
to carry objects. Always use cargo tie-down
rings, and if so equipped, always use the cargo
net when transporting cargo.
Never drive a vehicle with the tailgate open.
Deadly carbon monoxide (CO) gases may
enter vehicle interior resulting in
unconsciousness and death.
The gross vehicle weight (GVW) is the vehicle weight including fuel, vehicle tool kit, spare wheel, installed accessories, vehicle occupants and luggage/cargo.
The gross load limit and the gross vehicle weight rating (GVWR) for your vehicle must never be exceeded. The gross load limit and the GVWR are specified on the vehicle identification plate on the B-pillar of the driver's door.
The load must also be distributed so that the weight on each axle never exceeds the gross axle weight rating (GAWR) for the front and rear axles. The specifications for GVWR and GAWR are on the vehicle identification plate on the B-pillar of the driver's door.
Further information can be found in the "Loading the vehicle" section.
The handling characteristics of a laden vehicle are dependent on the distribution of the load within the vehicle. For this reason, you should observe the following notes when transporting a load:
• position heavy loads as far forwards as
possible and as low down in the cargo
compartment as possible.
• the load must not protrude above the upper
edge of the seat backrests.
• always place the load against the rear or
front seat backrests. Make sure that the
seat backrests are securely locked into
place.
• hook in the cargo net when loading.
• always place the load behind unoccupied
seats if possible.
• secure the load with sufficiently strong
and
wear-resistant tie down. pad sharp edges
for protection.
See also:
Tire pressure specifications
WARNING
Follow recommended tire inflation pressures.
Do not underinflate tires. Underinflated tires
wear excessively and/or unevenly, adversely
affect handling and fuel economy, and ...
Active Curve System
The Active Curve System uses active
stabilizers to optimize both driving comfort
and vehicle agility. Depending on the ADS
mode selected (Y page 180), the Active Curve
System also changes the ...
Automatic locking feature
The vehicle locks automatically when the
ignition is switched on and the wheels of the vehicle are turning at a speed of
more than
9 mph (15 km/h).
You could therefore be locked out when:
• th ...
