Snow chains

For safety reasons, Mercedes-Benz recommends that you only use snow chains which have been specially approved for your vehicle by Mercedes-Benz, or are of a corresponding standard of quality.

System (ADS): do not drive in ADS SPORT Vehicles with the Adaptive Damping System (ADS): do not drive in ADS SPORT mode if snow chains have been mounted.

The vehicle may otherwise be damaged.

chains on some wheel sizes. Observe the There is not enough space for snow chains on some wheel sizes. Observe the information under "Tires and wheels" in the "Technical Data" section to avoid damage to the vehicle or the wheels.

Only use snow chains when driving on roads completely covered by snow. Do not exceed the maximum permissible speed of 30 mph (50 km/h). Remove the snow chains as soon as possible when you are no longer driving on snow-covered roads.

Local regulations may restrict the use of snow chains. Applicable regulations must be observed if you wish to mount snow chains.

Snow chains must not be mounted on emergency spare wheels.

If you intend to mount snow chains, please bear the following points in mind:

you may not attach snow chains to all wheel-tire combinations; see the information under "Wheel and tire combinations" in the "Wheels and tires" section.

mount snow chains only in pairs and only to the rear wheels. Observe the manufacturer's installation instructions.

wheels, the snow chains could grind If snow chains are mounted on the front wheels, the snow chains could grind against the bodywork or components of the chassis. This could result in damage to the vehicle or the tires.

to install snow chains to steel wheels, make Vehicles with steel wheels: if you wish to install snow chains to steel wheels, make sure that you remove the respective wheels' hubcaps first. The hubcaps may otherwise be damaged.

ESP®() when pulling away with You may wish to deactivate ESP®() when pulling away with snow chains mounted. This way you can allow the wheels to spin in a controlled manner, achieving an increased driving force (cutting action).

    See also:

    Calling up a stored setting
    - Press and hold the relevant storage position button 1, 2 or 3 until the seat, steering wheel and exterior mirrors are in the stored position. The setting procedure is interrupted as soon ...

    Overhead control panel
    Switches the rear interior lighting on/off Switches the automatic interior lighting control on/off Switches the righthand reading lamp on/off Opens/closes the panorama roof ...

    Additives
    Only use DEF in accordance with ISO 22241. Do not use additives with DEF and do not dilute DEF with water. This may destroy the BlueTEC exhaust gas aftertreatment system. ...