Transfer case

The vehicle has permanent 4-wheel drive (4MATIC). Power is always transmitted to both axles.

out on a 2-axle dynamometer. The brake Performance tests may only be carried out on a 2-axle dynamometer. The brake system or transfer case could otherwise be damaged. Contact a qualified specialist workshop for a performance test.

Mercedes-Benz recommends that you use an authorized Mercedes-Benz Center for this purpose.

brake dynamometer, the ignition must be If the parking brake is being tested on a brake dynamometer, the ignition must be switched off (SmartKey or Start/Stop button in position 0 or 1), as ESP® will otherwise automatically intervene. The test must last a maximum of 10 seconds. The brake system could otherwise be damaged.

    See also:

    Cleaning the plastic trim
    WARNING When cleaning the steering wheel boss and dashboard, do not use cockpit sprays or cleaning agents containing solvents. Cleaning agents containing solvents cause the surface to becom ...

    installing and removing the seat cushion
    You must remove the seat cushion if you wish to lift the trunk floor, e.g. if the vehicle has a flat tire. •► To remove: fold seat cushion 2 upwards and remove it from seat cushion gu ...

    Setting and storing the parking position
    You can position the front-passenger side exterior mirror in such a way that you can see the rear wheel on that side as soon as you engage reverse gear. You can store this position. Make s ...