Changing the settings of the lockingsystem
You can change the setting of the locking system in such a way that only the driver's door and the fuel filler flap are unlocked. This is useful if you frequently travel on your own.
► To change the setting: press and hold
down the 
buttons
simultaneously for approximately six
seconds until the battery check lamp flashes twice.
If the setting of the locking system is
changed within the signal range of the
vehicle, pressing the 
button
locks or unlocks the vehicle.
The SmartKey now functions as follows:
► To unlock the driver's door: press the
button once.
► To unlock centrally: press the
button twice.
► To lock centrally: press the
button.
The KEYLESS-GO function is changed as follows:
► To unlock the driver's door: touch the
inner surface of the door handle on the
driver's door
► To unlock centrally: touch the inner
surface of the door handle on the frontpassenger
door or the rear door.
► To lock centrally: press the locking
button
on one of the door handles.
See also:
The windshield wipers are obstructed
Leaves or snow, for example, may be
obstructing the windshield wiper movement.
The wiper motor has been deactivated.
For safety reasons, you should remove the
SmartKey from the ignition lock.
...
Trip computer "From start" or "Fromreset"
The values in the From Start submenu refer
to the start of your journey, while those in the
From Reset submenu refer to the last time
you reset this submenu.
► Press the
button on the
s ...
DISTRONIC displays in thespeedometer
When DISTRONIC is activated, one or
two segments in the set speed range light up.
For design reasons, the speed displayed
in the speedometer may differ slightly from
the speed set for DISTRON ...