Checking tire pressure electronically
- Make sure that the SmartKey is in position 2 () in the ignition lock.
- Press the
or
button on the steering wheel to
select the Service menu. - Press the
or
button to select Tire Pressure. - Press the
button. The current
tire pressure for each wheel will be displayed in the multifunction display.
If the vehicle has been parked for longer than 20 minutes, the Tire pressures will be displayed after driving a few minutes message appears in the display.
After a teach-in period, the tire pressure monitor automatically recognizes new wheels or new sensors. If a clear allocation of the tire pressure values to the individual wheels is not possible, the Tire Pressure Monitor Active message is shown instead of the tire pressure display. The tire pressures are already being monitored.
If a spare wheel/emergency spare wheel is mounted, the system may continue
to show the tire pressure of the wheel that has been removed for a few minutes.
If this occurs, note that the value displayed for the position where the spare tire
is mounted is not the same as the spare wheel/emergency spare wheel's current tire
pressure.
See also:
Important safety notes
WARNING
The following factors increase the risk of accidents:
Excessive speed, especially in turns
Wet and slippery road surfaces
Following another vehicle too closely
The driving saf ...
Checking the oil level using the oil
dipstick
On vehicles with a 12-cylinder engine, the oil
level can be checked using the on-board
computer. On all other models, the dipstick
must be used to check the engine oil level.
Example: vehic ...
Blind Spot Assist
Important safety notes
Blind Spot Assist uses a radar sensor system
to monitor the areas on both sides of your
vehicle. It supports you from speeds of
approximately 20 mph (30 km/h). A warning ...
