Fuse box in the engine compartment
- Make sure that the windshield wipers are turned off.
WARNING
Make sure that the windshield wipers are switched off and that the SmartKey is removed from the ignition lock before you open the cover of the fuse box. Otherwise, the windshield wipers and the wiper rods above the cover could be set in motion. This could lead to you or others being injured by the wiper rods.
- Open the hood ().
- Remove any existing moisture from the fuse box using a dry cloth.
- Take lines 2 from the guides.
- To open: open clamps 1.
- Remove the fuse box cover forwards.
Make sure that no moisture can enter the fuse box when the cover is open.
- To close: check whether the rubber seal is lying correctly in the cover.
- Insert the cover at the rear of the fuse box into the retainer.
- Fold down the cover and close clamps 1.
- Secure lines 2 in the guides.
The cover must be seated properly, otherwise moisture or dirt could impair
the function of the fuses.
- Close the hood ().
See also:
Vehicle identification number (VIN)
The vehicle identification number (VIN) can
be found in the following locations:
- on the vehicle identification plate
- at the lower edge of the windshield
In addition to being stamped on the ve ...
Low-beam headlamps
► To switch on the low-beam headlamps:
turn the SmartKey in the ignition lock to
position 2 or start the engine.
► Turn the light switch to
.
The indicator lamp in the
instru ...
Detaching and storing the cargo net
Detach guide rod 2 from bracket 1 ().
Press the red button on the upper and lower guide rods.
Fold the cargo net and roll it up.
Close the two Velcro fasteners on the cargo net holder.
...