Introduction
You can establish a Bluetooth® connection to the audio system or to COMAND (see the separate operating instructions).
WARNING
A driver's attention to the road must always be his/her primary focus when driving. For your safety and the safety of others, we recommend that you pull over to a safe location and stop before placing or taking a telephone call. If you choose to use the telephone while driving, please use the handsfree device and only use the telephone when weather, road and traffic conditions permit.
Some jurisdictions prohibit the driver from using a mobile phone while driving a vehicle.
Bear in mind that at a speed of just 30 mph (approximately 50 km/h ), your vehicle is covering a distance of 44 feet (approximately 14 m) every second.
- Switch on the mobile phone and audio system or COMAND (see the separate operating instructions).
- Press the
or
button on the steering wheel to select the Tel menu.
You will see one of the following display messages in the multifunction display:
- Telephone Ready or the name of the network provider: the mobile phone has found a network and is ready to receive.
- Phone No Service: no network is available, or the mobile phone is searching for a network.
See also:
Trip computer "From start" or "From
reset"
The values in the From Start submenu are
calculated from the start of a journey, while
the values in the From Reset submenu are
calculated from the last time the submenu
was reset.
– Press th ...
Setting the map to the vehicle position,
intermediate stop or destination
position
Centering the map on the vehicle position
To show the menu: press
the COMAND
controller.
Select Position in the navigation system
menu bar by sliding and turning
the COMAND controller a ...