Transfer case
This section is only valid for vehicles with 4- wheel drive (4MATIC). Power is always transmitted to both axles.
Performance tests may only be carried out on a 2-axle dynamometer. The brake
system or transfer case could otherwise be damaged. Contact a qualified specialist
workshop for a performance test. Mercedes-Benz recommends that you use an authorized
Mercedes-Benz Center for this purpose.
To prevent ESP® from intervening, the ignition must be switched off (SmartKey
in position 0 or 1) if:
- the parking brake is being tested on a brake dynamometer.
- the vehicle is being towed with only one axle raised (not permitted for vehicles with 4MATIC).
The brake system could otherwise be damaged.
See also:
Making adjustments in 1 mph (Canada:
1 km/h) increments
Briefly press the cruise control lever to the
pressure point, up 1 for a higher speed or
down 2 for a lower speed.
The last speed stored is increased or
reduced. ...
Folding the seat backrest back
Folding the seat backrest back
Move the driver's or
front-passenger seat
forward if necessary.
Make sure that the seat belt
does not
become trapped when folding the rear seat
backrest ...
Lowering the vehicle
Turn the crank of the jack counterclockwise
until the vehicle is once again
standing firmly on the ground.
Place the jack to one side.
Tighten the wheel bolts evenly in a ...
