Turn signal lamps/side marker lamps

  • Switch off the lights.
  • Open the hood.
  • Remove the headlamp cover ().
  • Left-hand headlamp: detach the washer fluid reservoir ().
  • Turn bulb holder 1 or 2 counterclockwise and pull it out.
  • WY 5 W (turn signal lamp and side marker lamp): remove the bulb from bulb holder 1.
  • PY 21 W (turn signal lamp): turn the bulb counter-clockwise, applying slight pressure, and remove it from bulb holder 2.
  • WY 5 W (turn signal lamp and side marker lamp): insert the new bulb into bulb holder 1.
  • PY 21 W (turn signal lamp): insert the new bulb into bulb holder 2 and turn it clockwise while applying slight pressure.
  • Insert bulb holder 1 or 2 and turn it clockwise.
  • Left-hand headlamp: fasten the washer fluid reservoir ().
  • Install the headlamp cover ().
    See also:

    General notes
    USA only: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. this device must a ...

    Cleaning the sensors
      Clean sensors 1 of the driving systems with water, car shampoo and a soft cloth. When cleaning the sensors with a power washer, maintain a distance between the vehicle and the nozzl ...

    Shift ranges
    Introduction When the automatic transmission is in position D, it is possible to restrict or derestrict the shift range. The shift range selected is shown in the multifunction display. The aut ...