High-beam headlamps (halogen headlamps)

  • Switch off the lights.
  • Open the hood.
  • Remove the headlamp cover ().
  • Left-hand headlamp: detach the washer fluid reservoir ().
  • Turn housing cover 1 counter-clockwise and pull it out.
  • Press the handle of bulb holder 2 in the direction of the arrow until bulb holder 2 is released.
  • Take out the handle with bulb holder 2.
  • Take the bulb out of bulb holder 2.

  • Insert the new bulb into bulb holder 2. Lug 3 of the bulb must be pointing upward.
  • Insert bulb holder 2.
  • Push the handle of bulb holder 2 in the opposite direction from the arrow until holder 2 engages.
  • Align housing cover 1 and turn it clockwise until it engages.
  • Left-hand headlamp: fasten the washer fluid reservoir ().
  • Install the headlamp cover ().
    See also:

    Driving with summer tires
    At temperatures below 45 ‡ (+7 †), the elasticity of summer tires and therefore also traction and braking capability are reduced considerably — equip your vehicle with M+S tires. Using summer tire ...

    Belt warning for the driver and front passenger
    Regardless of whether the driver and front passenger have fastened their seat belts already, the7seat belt warning lamp lights up for seconds after every engine start. It then goes out if t ...

    Problems with the seat heating
    The seat heating has switched off prematurely or cannot be switched on. The vehicle's electrical system voltage is too low because too many electrical consumers are switched on. •► Swit ...