Low-beam headlamps (halogen headlamps)

  • Switch off the lights.
  • Open the hood.
  • Remove the headlamp cover ().
  • Left-hand headlamp: detach the washer fluid reservoir ().
  • Turn housing cover 1 counter-clockwise and pull it out.
  • Pull connector 2 from bulb 4.
  • Unclip retaining spring 3 and fold it down.
  • Pull out bulb 4.
  • Insert the new bulb.
  • Clip retaining spring 3 back in.
  • Attach connector 2 to bulb 4.
  • Attach housing cover 1 and turn it clockwise until it engages.
  • Left-hand headlamp: fasten the washer fluid reservoir ().
  • Install the headlamp cover ().
    See also:

    Notes on audio AUX mode
    You can connect an external audio source (AUX) to COMAND. The socket for this is located in the glove box. If COMAND is equipped with a Media Interface, external audio sources are connected u ...

    Adaptive Highbeam Assist
    You can use this function to set the headlamps to change between low beam and high beam automatically. The system recognizes vehicles with their lights on, either approaching from the opposite ...

    Folding the exterior mirrors in or out electrically
    Make sure that the SmartKey is in position 1 or 2 in the ignition lock. Briefly press button 1. Both exterior mirrors fold in or out. Make sure that the exterior mirrors are always fol ...