Removing/installing the headlamp cover

You must remove the headlamp cover in the engine compartment before you can replace the bulbs in the headlamp.

  1. To remove: press retaining clip 1 in the direction of the arrow.
  2. Pull cover 2 forward underneath cover 3 and remove.
  3. To install: slide cover 2 under cover 3. Connect the two covers by inserting the tongue into the groove.
  4. Press cover 2 until retaining clip 1 engages.
    See also:

    Problems with the seat heating
    The seat heating has switched off prematurely or cannot be switched on. The vehicle's electrical system voltage is too low because too many electrical consumers are switched on. •► Swit ...

    Important safety notes
    WARNING The following factors increase the risk of accidents: • Excessive speed, especially in turns • Wet and slippery road surfaces • Following another vehicle too closely The drivi ...

    Accepting a call
    If someone calls you when you are in the Tel menu, a display message appears in the multifunction display, for example: Press the button on the steering wheel to accept an incoming call. If y ...