Cornering light function
The cornering light function improves the illumination of the road over a wide angle in the direction you are turning, enabling better visibility in tight bends, for example. It can only be activated when the low-beam headlamps are switched on.
Active: if you are driving at speeds below 25 mph (40 km/h) and switch on the turn signals or turn the steering wheel.
Not active: if you are driving at speeds above 25 mph (40 km/h) or switch off the turn signal or turn the steering wheel to the straight-ahead position.
The cornering light function may remain lit for a short time, but is automatically switched off after no more than three minutes.
See also:
Monitoring range of the sensors
Blind Spot Assist monitors the area shown in
the figure up to 10 ft (3 m) behind and
immediately adjacent to your vehicle.
WARNING
Blind Spot Assist monitors certain areas in the
im ...
Creating new contacts/changing
contacts
In certain countries, this function stops
being available from a vehicle speed of
more than approximately 3 mph (5 km/h).
As soon as the speed falls below
approximately 2 mph (3 km/h), the
f ...
High-beam flasher
To switch on: turn the
SmartKey in the
ignition lock to position 1 or 2 or start the
engine.
Pull the combination switch in the
direction
of arrow 3. ...