Resetting the panorama roof with power tilt/sliding panel and the roller sunblinds
Reset the panorama roof with power tilt/ sliding panel and the roller sunblinds if the panorama roof with power tilt/sliding panel or the roller sunblinds do not move smoothly.
- Turn the SmartKey to position 1 or 2 in the ignition lock.
- Press the
switch to the point
of resistance in the direction of arrow 2 and hold it until the panorama roof
with power tilt/sliding panel has opened about 4 in (10 cm). - Pull the
switch repeatedly
to the point of resistance in the direction of arrow 3 until the panorama roof
with power tilt/ sliding panel is fully closed. - Keep the
switch pulled for
an additional second. - Press the
switch to the point
of resistance in the direction of arrow 2 and hold it until the sunblinds have
opened about 4 in (10 cm). - Pull the
switch repeatedly
to the point of resistance in the direction of arrow 3 until the roller sunblinds
are fully closed. - Keep the
switch pulled for
an additional second. - Make sure that the panorama roof with power tilt/sliding panel and the roller sunblinds can be fully opened and closed again ().
- If this is not the case, repeat the steps above again.
If the panorama roof with power tilt/ sliding panel and the roller sunblind
cannot be fully opened or closed after resetting, contact a qualified specialist
workshop.
See also:
General notes
The roller sunblinds shield the vehicle interior
from sunlight. The front roller sunblind can
only be opened and closed when the
panorama roof with power tilt/sliding panel
is closed. The fron ...
General notes
If you cannot lock or unlock the vehicle with
the SmartKey, either the battery in the
SmartKey is discharged, the SmartKey is
faulty or the starter battery is discharged.
•► Check the bat ...
Important safety notes
Blind Spot Assist uses a radar sensor system
to monitor the areas on both sides of your
vehicle. It begins to work at speeds of
approximately 20 mph (30 km/h). A warning
display in the exterior mi ...
