Resetting triggered NECK-PRO head restraints
WARNING
For safety reasons, have the NECK-PRO head restraints checked at an authorized Mercedes-Benz Center after a rear-end collision.
WARNING
When pushing back the NECK-PRO head restraint cushion, make sure your fingers do not become caught between the head restraint cushion and the cover. Failure to observe this could result in injuries.
Resetting the NECK-PRO head restraints requires a lot of strength. If you have difficulty resetting the NECK-PRO head restraints, have this work carried out at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.

- Press the base of the NECK-PRO head restraint cushion back in the direction of arrow 2 as far as it will go.
- Push the NECK-PRO head restraint cushion down into the guide in the direction of arrow 3 as far as it will go.
- Firmly fold the NECK-PRO head restraint cushion back in the direction of arrow 1 until it engages.
- Repeat this procedure for the second NECK-PRO head restraint.
See also:
Seat belt
Display messages
Possible causes/consequences and Solutions
After starting
the engine, the red seat belt warning lamp lights up for six seconds.
The seat belt warning lam ...
Vehicle identification p
Even if you have calculated the total load
carefully, you should still make sure that the
gross vehicle weight rating and the gross axle
weight rating are not exceeded. Details can
be found on the ...
EASY-PACK load-securing kit (Wagon)
Components and storage
The EASY-PACK load-securing kit allows you
to use your cargo compartment for a variety
of purposes. The accessory parts are located
under the cargo compartment floor.
•& ...
