Restarting the tire pressure monitor

WARNING
It is the driver's responsibility to set the tire pressure to the recommended cold tire pressure. Underinflated tires affect the ability to steer or brake the vehicle. You might lose control over the vehicle.

When you restart the tire pressure monitor, all existing warning messages are deleted and the warning lamps go out. The monitor uses the currently set tire pressures as the reference values for monitoring.

The tire pressure monitor must be restarted when you set the tire pressure to a new value (as a result of changed drive or load characteristics, for example). The tire pressure monitor then monitors the new tire pressure values.

pressure monitor recognizes the new Canada only: in most cases, the tire pressure monitor recognizes the new reference values automatically. However, you can also define reference values manually as described here.

Restart the tire pressure monitor after you have set the tire pressure to the value recommended for the desired driving situation. Only correct tire pressures on cold tires. Comply with the recommended tire pressures on the Tire and Loading Information placard on the B-pillar on the driver's side. Additional tire pressure values for driving at high speeds or with heavy loads can be found in the tire pressure table on the inside of the fuel filler flap.

on all four wheels. Make sure that the tire pressure is correct on all four wheels.

2 in the ignition lock. Make sure that the SmartKey is in position 2 in the ignition lock.

button on the Press the button on the or steering wheel to select the Service button on the steering wheel to select the Service menu.

button to select Press the button to select or Tire Pressure. button to select Tire Pressure.

The multifunction display shows the Press the The multifunction display shows the button.

The multifunction display shows the current tire pressure of the individual tires or the Tire Pressures Displayed After Driving A Few Minutes message.

The Use Current Pressures As New Press the The Use Current Pressures As New button.

The Use Current Pressures As New Reference Values message appears in the multifunction display.

If you wish to confirm the restart:

The Tire Pressure Monitor Press the The Tire Pressure Monitor button.

The Tire Pressure Monitor Restarted message appears in the multifunction display.

After driving for a few minutes, the system checks whether the current tire pressures are within the specified range. The new tire pressures are then accepted as reference values and monitored.

If you wish to cancel the restart:

The tire pressure values stored at the last Press the The tire pressure values stored at the last button.

The tire pressure values stored at the last restart will continue to be monitored.

    See also:

    Please bear the following in mind
    Resetting the service interval display A qualified specialist workshop, e.g. an authorized Mercedes-Benz Center, will reset the service interval display after the necessary service work has been c ...

    Cleaning the wheels
    WARNING Do not use power washers with circular-jet nozzles (dirt grinders) to clean your vehicle, in particular the tires. You could otherwise damage the tires and cause an accident. ...

    Using the TIREFIT kit
    You can use the TIREFIT kit to seal small punctures, particularly those in the tire tread. You can use TIREFIT at outside temperatures down to -4 °F (-20 °C). WARNING TIREFIT is a limited repa ...