Preparing the vehicle
Your vehicle may be equipped with a "Minispare" emergency spare wheel or MOExtended tires (tires with run-flat properties).
Vehicle preparation is not necessary on
vehicles with MOExtended tires.
Stop the vehicle as far away as possible
from traffic on solid, non-slippery and level
ground.
Switch on the hazard warning lamps.
Engage the electric parking brake manually.
Bring the front wheels into the straightahead
position.
Move the DIRECT SELECT lever to P.
Switch off the engine.
Vehicles without KEYLESS-GO: remove
the SmartKey from the ignition lock.
Vehicles with KEYLESS-GO: open the
driver's door.
The on-board electronics have status 0, which is the same as the SmartKey having been removed.
Vehicles with KEYLESS-GO: remove the
Start/Stop button from the ignition lock.
All occupants must get out of the vehicle.
Make sure that they are not endangered as they do so.
Make sure that no one is near the danger
area while a wheel is being changed.
Anyone who is not directly assisting in the wheel change should, for example, stand behind the barrier.
Get out of the vehicle. Pay attention to
traffic conditions when doing so.
Close the driver's door.
See also:
Important notes on use
To function properly, BlueTEC exhaust gas
aftertreatment must be operated with the
reducing agent DEF. Adding DEF is one of the
tasks performed during maintenance. Under
normal operating condi ...
Limited Warranty
Follow the instructions in this manual
about the proper operation of your vehicle
as well as about possible vehicle damage.
Damage to your vehicle that arises from
culpable contraventions agai ...
Cargo tie-down rings
Observe the following notes on securing loads:
secure the load using the cargo tie down rings.
do not use elastic straps or nets to secure a load, as these are only intended
as an anti-slip p ...
